Spacer Kit for BBS02, and HD Bottom Bracket Fitting

19.95AUD
(3 reviews) Write a Review
Width:
6.00 (cm)
Height:
3.00 (cm)
Depth:
2.00 (cm)
Fixed Shipping Cost:
12.00AUD
Current Stock:
  • Aluminum spacers for fitting of the BBSHD
  • Helps with odd sized Bottom Brackets and other fitting issues
  • Includes 4 spacers, 2 medium  (2mm) and 2 large spacer (3mm)
  • Go around the shaft of the BBSHD and fit like a glove
  • If the triangle plate lines up with the two bolt attachments but is not flush against the BB of the frame then these are the spacers you are looking for
  • For more info on mounting the BBSHD on fatbikes with intrusive chainstays check out (this article).

We provide this kit so that you have a wide range of spacers to make  sure your BBSHD gets good fitment.

 

With this combination you can get up to 10mm of wiggle room with your BBSHD install. 

According to Karl from electricbike-blog.com the golden rule of BBSHD installation is "Your mounting plate must be totally flat against the bottom bracket Side"

These spacers make that a cinch to happen. 

Reviews

  • 3
    A requirement

    Posted by Joshua Stretton on 16th Jun 2020

    Couldn't finish the product without it. 4 spacers with 2 sizes. It really helps to align the equipment with the bike.

  • 5
    Spacer Kit

    Posted by Mark van der Zwaag on 29th Jun 2019

    Great kit, it works well. I needed the 1mm spacer to clear the motor from the chain stay and it did well. I recommend it for the fine tuning of the motor position.

  • 5
    Spacer kit

    Posted by Wade on 13th Apr 2018

    Great product .. get you out of trouble and on the road